LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Vehicle Dynamic Suspension >> Vehicle Dynamic Suspension >> Removal And Installation >> Air Suspension Reservoir Solenoid Valve Block >> Installation

Air Suspension Reservoir Solenoid Valve Block: Installation

    CAUTION: Make sure the new Voss connector is installed and fully tightened with the alignment plug installed.
    NOTE: New air suspension components are supplied with new Voss connectors tightened to the correct torque. Do not install new voss connectors if a new component is being installed.
  1. Install new Voss connectors to the air suspension reservoir solenoid valve block.
    • Tighten to 2.5 Nm (1.7 lb.ft).
    2. NOTE: Make sure the valve block does not become detached during connection of the air lines.
  2. Install the air suspension reservoir solenoid valve block.
    • Secure the 3 valve block rubber insulators.
    • Connect the electrical connectors.
    • Connect the air lines into the Voss connector.
    • Pull on each air line to make sure it is fully installed into the Voss connecter.
  3. Secure the air compressor electrical connector.
  4. Install the air suspension compressor lower cover.
    • Install the bolts and tighten to 10 Nm (7 lb.ft).
  5. Using T4, pressurize the air suspension. See Air Suspension System Depressurize and Pressurize .
scientia non olet · About LEMON Manuals