Air Suspension Compressor Drier: Removal
CAUTION:
If a new air suspension compressor, air compressor drier or air compressor delivery valve kit is installed due to failure, an air compressor relay must be installed. Failure to follow this instruction may result in damage to the air suspension system components.
- Raise and support the vehicle.
- Remove the air suspension compressor. See Air Suspension Compressor . .
- Disconnect the air line from the air suspension compressor drier.
- Release the air line from the retaining clip.
- Remove the air suspension compressor drier.
- Remove the retaining screw.
- Remove and discard the O-ring seal.
WARNING:
Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
CAUTION:
Before disconnecting or removing the components, ensure the area around the joint faces and connections are clean and dry. Plug open connections to prevent contamination.
NOTE:
If equipped, note the position of the air suspension compressor retaining cable.
