Air Suspension Front Solenoid Valve Block: Removal
- Raise and support the vehicle.
- Remove the RH fender splash shield. Refer to Fender Splash Shield article.
- Using T4, depressurize the air suspension. See Air Suspension System Depressurize and Pressurize .
- Disconnect the 3 air lines from the air suspension front solenoid valve block.
- Remove the air suspension front solenoid valve block.
- Disconnect the electrical connector.
- Release the valve block 3 rubber insulators.
- Remove the Voss connectors from the air lines.
- Remove and discard the collet and the union.
WARNING:
Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
CAUTION:
Before the disconnection or removal of any components, ensure the area around joint faces and connections are clean. Plug any open connections to prevent contamination.
CAUTION:
Visually inspect the air line ends for damage or wear. Repair or replace the air line as necessary.
NOTE:
Note the air line fitted positions.
