LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Vehicle Dynamic Suspension >> Vehicle Dynamic Suspension >> Removal And Installation >> Air Suspension Front Solenoid Valve Block >> Installation

Air Suspension Front Solenoid Valve Block: Installation

    CAUTION: Make sure the new Voss connector is installed and fully tightened with the alignment plug installed.
    NOTE: New air suspension components are supplied with new Voss connectors tightened to the correct torque. Do not install new voss connectors if a new component is being installed.
  1. Install new Voss connectors to the air suspension front solenoid valve block.
    • Tighten to 2.5 Nm (1.7 lb.ft).
    2. NOTE: Make sure the valve block does not become detached during connection of the air lines.
  2. Install the air suspension front solenoid valve block.
    • Secure the 3 valve block rubber insulators.
    • Connect the air lines into the Voss connector.
    • Pull on each air line to make sure it is fully installed into the Voss connecter.
    • Connect the electrical connector.
  3. Using T4, pressurize the air suspension. See Air Suspension System Depressurize and Pressurize .
  4. Install the RH fender splash shield. Refer to Fender Splash Shield article.
scientia non olet · About LEMON Manuals