Air Suspension Rear Solenoid Valve Block: Installation
- Install new Voss connectors to the rear valve block.
- Tighten to 2.5 Nm (1.7 lb.ft).
- Install the rear valve block.
- Secure the 3 valve block rubber insulators.
- Connect the electrical connector.
- Connect the air lines into the Voss connector.
- Pull on each air line to make sure it is fully installed into the Voss connecter.
- Using T4, pressurize the air suspension. See Air Suspension System Depressurize and Pressurize .
- Install the wheel and tire.
- Tighten the wheel nuts to 140 Nm (103 lb.ft).
NOTE:
New air suspension components are supplied with new Voss connectors tightened to the correct torque. Do not install new voss connectors if a new component is being installed.