Front Shock Absorber And Air Spring Assembly: Installation
- Install a new Voss connector to the air spring.
- Tighten to 3.5 Nm (2.6 lb.ft)
- Install the shock absorber and air spring assembly.
- Connect the air line into the Voss connector.
- Pull on the air line to make sure it is fully installed into the Voss connector.
- Install the nuts and tighten to 63 Nm (46 lb.ft).
- Connect the shock absorber and air spring assembly to the lower arm.
- Tighten the nut and bolt to 300 Nm (221 lb.ft).
- Using the Land Rover approved diagnostic system, pressurize the air suspension. See Air Suspension System Depressurize and Pressurize .
- Install the wheel and tire.
- Tighten the wheel nuts to 140 Nm (103 lb.ft).
CAUTION:
Make sure the new Voss connector is installed and fully tightened with the alignment plug installed.
NOTE:
Remove and discard the blanking caps.
NOTE:
Clean the component mating faces.