LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Vehicle Dynamic Suspension >> Vehicle Dynamic Suspension >> Removal And Installation >> Rear Shock Absorber And Air Spring Assembly >> Installation

Rear Shock Absorber And Air Spring Assembly: Installation

  1. Install the shock absorber and air spring assembly.
    • Make sure the shock absorber and air spring assembly top mounting to body mating faces are clean.
    • Fit the nuts and tighten to 63 Nm (46 lb.ft).
    • Connect the air line into the Voss connector.
    • Pull on the air line to make sure it is fully installed into the Voss connecter.
  2. Connect the shock absorber and air spring assembly to the lower arm.
    • Tighten the nut and bolt to 300 Nm (221 lb.ft).
  3. Using the Land Rover approved diagnostic system, pressurize the air suspension. See Air Suspension System Depressurize and Pressurize .
  4. Tighten the shock absorber and air spring assembly to the lower arm.
    • Tighten the nut and bolt to 300 Nm (221 lb.ft).
    5. CAUTION: Make sure the new Voss connector is installed and fully tightened with the alignment plug installed.
  5. Install a new Voss connector to the air spring.
    • Tighten to 3.5 Nm (2.6 lb.ft)
    • Attach the active damping wiring.
  6. Install the wheel and tire.
    • Tighten the wheel nuts to 140 Nm (103 lb.ft).
  7. Lower the vehicle on the lift.
  8. Connect the spare wheel release strap to the spare wheel and tire.
  9. Install the spare wheel and tire.
    • Raise the spare wheel and tire.
  10. Install the spare wheel/tool compartment cover.
  11. Install the jack and wheel brace.
  12. Install the loadspace floor panel.
scientia non olet · About LEMON Manuals