Air Suspension Pressure Sensor: Removal
- Raise and support the vehicle.
- Remove the air compressor housing cover.
- Remove the 3 bolts.
- Release the 5 clips.
- Using T4, depressurize the air suspension. See Air Suspension System Depressurize and Pressurize .
- Disconnect the electrical connector.
- Remove the air pressure sensor.
- Remove and discard the O-ring seal.
WARNING:
Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
NOTE:
Make sure the valve block does not become detached during removal of the air pressure sensor.
CAUTION:
Before the disconnection or removal of any components, ensure the area around joint faces and connections are clean. Plug any open connections to prevent contamination.
