Rear Quarter Window Glass: Removal
CAUTION:
Always protect paintwork and glass when removing exterior components.
CAUTION:
Always protect the interior components when removing body glass.
CAUTION:
Lay the glass on felt covered supports. Do not stand on edge as this can cause chips which subsequently develop into cracks.
NOTE:
The following equipment is required:
- Cutting wire and handles
- Kent knife
- Glazing knife
- Glass replacement kit
- Sealant applicator gun
- Suction cups
- A felt covered table or stand to support glass
- Remove the D-pillar upper trim panel. Refer to D-Pillar Trim Panel .
- Remove the rear quarter window glass panel.
- Release the 3 clips.
- Disconnect the rear quarter window glass antenna connector.
- With assistance, remove the rear quarter window glass.
- Carefully cut through the sealant using a glazing knife or cutting wire.
- Attach the suction cups.
- Noting fitted position, remove the 4 spacers.
WARNING:
Eye protection must be worn.
CAUTION:
Care must be taken not to damage the air bag curtain module when cutting through the sealant.
