LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Land Rover >> 2012 >> LR4 HSE Lux >> Repair and Diagnosis (Single Page) >> Body & Frame >> Sun Roof/T-Top/Convertible Top >> Roof Opening Panel >> Roof Opening Panel >> Diagnostic Procedures >> Roof Opening Panel >> DTC Index >> Pinpoint Test C: Roof Opening Panel - During Operation

Pinpoint Test C: Roof Opening Panel - During Operation

C1: NOISE 

NOTE: These tests are to be carried out to determine the cause of the noise in relation to the roof opening panel
NOTE: If the customer concern is related wind noise, refer to the symptom chart above
  1. Confirm customer complaint, locate the noise, by operating the roof opening panel through all possible positions (slide open / slide close / tilt open / tilt close) using the roof mounted switch
  2. Determine the cause of the noise
  3. Is the noise evident only  during operation of the roof opening panel?

    Yes: 

    The noise is evident during (slide open / slide close / tilt open / tilt close) operation GO to Pinpoint Test D .

    No: 

    (1)  The noise is evident during inputs from the vehicle GO to C2  . Or  , (2)  the customer symptom is not evident. No further action required

C2: AIR DEFLECTOR - ALIGNMENT AND NOISE 

  1. Carry out visual inspection of the wind deflector, confirm the position is correct, the left / right buffers are present and the springs are in good condition
    G00523483
  2. See figure
    G00523487
  3. Is the position of the wind deflector correct, with the left / right buffers present and the springs are in good condition?

    Yes: 

    GO to C3  .

    No: 

    Correctly reinstall or replace the wind deflector (buffers or springs) as required. Check for correct operation, If correct no further action required. If customer concern is still evident GO to C3  .

C3: MOTOR FIXING - SECURITY, LOCATION AND TORQUE 

  1. Carry out visual inspection of the roof opening panel motor for location and security of fixings
  2. Is the roof opening panel motor correctly located and securely installed?

    Yes: 

    GO to C4  .

    No: 

    Re-torque the fixings, TORQUE 3NM ± 0.25  if this is not possible replace the roof opening panel REFER to: Roof Opening Panel .

C4: ROLLO BLIND NOISE 

  1. Operate the rollo blind
  2. Does the rollo blind retract correctly without noise?

    Yes: 

    GO to C5  .

    No: 

    GO to Pinpoint Test F .

C5: MOTOR NOISE 

  1. Operate the roof opening panel
  2. During operation is the motor noise acceptable? (compare to other vehicles) 

    Yes: 

    If customer concern is still evident contact dealer technical support

    No: 

    Install a new roof opening panel motor REFER to: Roof Opening Panel Motor . Check for correct operation, If correct no further action required