Pinpoint Test A: Buckle Pre TENSIONER Diagnostic

A1: DIAGNOSTIC PROCEDURE

WARNING: Prior to any work on the SRS system the vehicle battery must be disconnected system the vehicle battery must be disconnected

WARNING: Please wait for 120 seconds to allow the air bag deployment energy reserve to dissipate

Check location of harness fly-lead ensuring there is no risk snagging and sufficient strain relief during full seat travel
Disconnect under-seat buckle pre tensioner connectors
Check connector for water ingress or signs of corrosion (white/green residue)
Check for debris in female connector and remove as required
Check for debris in male harness end connector and remove
Check that male connector pins are secure and in good condition
Check that all connector terminals are clean secure and in good condition
Reconnect the connector
- An audible click should be heard confirming security
Check actuator harness fly-lead is connected and correctly routed
Reconnect the vehicle battery
Clear the DTC, cycle the ignition state off / on wait 30 seconds and re-test
To confirm repair. While sitting in seat, retest as follows:
- Seat fully up - move fully backwards and forwards
- Seat fully down - move fully backwards and forwards

Is the warning lamp illuminated?

Yes . GO to Pinpoint Test B .

No . No further action required